‼️ Safety guidelines ‼️
For safety reasons during the COVID-19 pandemic, we cannot allow free and open access to the ADR/Foley suite. All use must be approved and scheduled by college administration. No walk-ins will be permitted.
To mitigate safety risks, there will be some important rules to follow:
- Only one person on the Foley stage and one person in the control room will be permitted.
- Face masks must be worn during the session.
- Students are asked to bring in their own props. If you don’t have access to a particular prop, you can make a request to Thomas to check it out.
- Rags and disinfectant will be provided. At the start of the session, students should wipe down any surfaces before touching them. At the end of the session, students should again wipe down any touched surfaces. Please be as attentive as possible to this.
Setting up the server
Make sure you have saved and closed your project on the Post Hall.
Confirm that The_Server is mounted on the desktop:
If not, from the Finder menu bar select “Go” and navigate to “Connect to Server”:
Then, for the Server Address, enter film-post-fs01.film.fsu.edu
Contact the Post Hall staff if you do not know the username and password.
Setting up the session
Select and power any appropriate video monitor on the Foley Stage:
- HDMI 1 is for Control Room A
- HDMI 2 is for Control Room B
Open Nuendo 8 from the Dock. The Nuendo Hub should open. Select your project from the list on the right hand window or select ”Open Other” and navigate to your .npr project file in your project folder on the Server:
From the Nuendo menu bar select “Studio” and navigate to “Audio Connections”:
Confirm all devices (the Steinberg I/O box on the workstation) are connected and mapped to the correct input and output ports.
Input Tab: the ADR Mic input 1 should be mapped to the corresponding Device Port and Foley Mic Input 2 should be mapped to its corresponding port:
Output Tab: The DxStem, FxStem and MxStems (Left, Right, Center) should be mapped to their corresponding L,R,C Device ports:
The Steinberg I/O Box should be set to the MASTER Position and left volume control should be set to maximum, fully clockwise:
Right-click over the track header section to create/select new tracks:
Make a sufficient number of tracks set to MONO configuration. You can name the tracks and assign to the appropriate Output Buss (or Stem):
Select the appropriate Input Path from the drop-down window in the track header of the Inspector:
Open the (previously prepared) Spotting Marker sheet. Click the “e” in the track header:
Click the ADR tab on the lower left of the spotting sheet, select the cue you wish to run.
Pre and Post Roll can be set in the General Tab by selection the setting icon on the bottom right corner, Video options are set in the Video Tab.
Record Enable the appropriate track:
Have your talent give you a test read to set initial recording levels using the preamp gain controls on the Steinberg I/O box. Peak readings should be bouncing up through Green and just into the Yellow on the track meters:
Use the Yellow Talkback box to communicate with your subject. Remember they cannot hear you otherwise!!
Use the Rehearse button to rehearse the first cue and re-adjust recording levels as needed. Peak meter readings should dance into the Yellow area:
When you are ready to start making “Takes” press the RECORD button in the Spotting sheet to start recordings. Redirect the talent as necessary until you are satisfied with the new performances.
The takes will be stacked on top of each other, indicated by the grey cross hatch:
To reveal the takes list, select the event, then control-right click and select “To Front”:
To playback your takes, simply deselect the record enable and play the clip.
Wrapping the session
Pick up after yourself. It is considered highly unprofessional to leave the Foley Pits or Control Rooms a mess. They are checked periodically and the last person(s) using the suite will be held accountable if the space has not been left in an unprofessional state.